Pump
GPN-1
As a Pump used in Nino model, is precisely machined, easier control over the discharge amount and boasts longer service life.
GP-2
GP2 is better than GP1 in quality and performance, easy to operate and not to require any seal. This is especially designed for high viscosity, high pressure and long run operation also available to check the flow rate even 1REV and control.
GP-7
The GP7 used for multi bend injector and can on / off individually.
GP-4
GP4 is designed for simplicity of flow control and reliability of operation also available to check flow rate per 1REV of Pump.
Compatible with JAPAN S Company
GP-5
GP5 Pump is using for highviscosity hot melt adhesive, checking discharge flow rate per 1REV of Pump.
Compatible with USA I Company
GPF
As a double gear Pump used in the FBS model, it was designed to be foamed by discharging in a uniform rate after mixing the molten hot melt a adhesive with CO2 or N2 gas.
GP-9
Large capacity Pump discharging 35cc of hot melt per rotation. Used for large consumtion.
GP-3
GP3 is totally sealant type Pump using for high viscosity hot melt adhesive, checking discharge flow rate per 1 REV of Pump.
Compatible with USA Nordson Company